If there is no water dispenser, throw away the first full batch or two of ice to make sure it is all clean and ready to use. A refrigerator with an automated ice maker and a built-in water dispenser does absolutely nothing if you do not have a water line to connect to it. A drain pump is a pump that pulls waste water away from different sources, including ice makers, and brings it to a kitchen drain.
Continue to 4 of 7 below. Connecting a water line for a refrigerator icemaker and water dispenser is easy with a convenient tee-fitting and flex hose supply tubing. If you are hooking up a refrigerator ice maker, find where it is located on the appliance.
Drill holes in the base cabinet walls to route the water line from beneath the sink to the rear of the refrigerator. In order to install the ice maker wiring, you'll need to find the wiring connection point. Located in the back of the freezer in the larger hole you just uncovered, is a . Attach the Adapt-a-Tee adapter to the shutoff valve, tightening by hand at first.
A drain pump is a pump that pulls waste water away from different sources, including ice makers, and brings it to a kitchen drain. Instructions on how to connect a reverse osmosis system to a refrigerator or ice maker and common challenges that may be encountered. Tighten the connections slightly if you see a leak.
Direct the end of your copper tubing unto a large bucket. Hooking Up a Refrigerator Ice Maker old or older, the ice maker, including the part that hooks up. If tightening the connection does not stop the leak, turn off the water, remove the connector and add additional thread-seal tape before reconnecting the water line.
You will have to wait hours before you have ice. Visit doslovno.info to learn more about how to hook up a water line to a bought a refrigerator with a cold water dispenser and automatic ice maker, you'll . She has several years of experience in the home-improvement industry, focusing on gardening, and a background in group exercise instruction.
In order to install the water valve, remove the back cover and expose the compressor area of the refrigerator. Related Articles.
Categories: Ice Makers.
Drill as close to the back wall of the cabinet as possible, so you do not lose storage space inside the cabinet.
Attach the free end of the copper tubing to the valve. Thread the ferrule from the kit onto the new line.